Thoroughly study all system components before proceeding with installation. Carefully review the mounting location options.

Maxi Thin Fanä applications should be connected directly, through its 15-amp fuse, to the battery. Do not exceed this 15-amp fuse. Warning: Do not connect Maxi Thin Fan’s power lead to Premier (Terminal 5) or Hotdog (Terminal 7) as this can cause an over current condition leading to Premier/Hotdog and Maxi system failure, endangering the K-9.

PIN 1 (shown in red) -- System Power 12VDC: Connect the RED wire of

the 12’ Red/Black zip wire direct from the vehicle battery via the 15-amp fuse link.

PIN 2 -- Ground: Connect the BLACK wire of the 12’ Red/Black zip wire direct from

the vehicle battery ground. Caution: Do not reverse the polarity.

PIN 3 -- Fan Power 12VDC: Connect the RED wire of the 6’ Red/Black zip wire to the fan.

PIN 4 -- Fan Ground: Connect the BLACK wire of the 6’ Red/Black zip wire to the fan.

PIN 5 -- Trigger: 4’ single 16awg Orange wire connects to Terminal # 3 of Premier

or Terminal # 6 of Hotdog™.

The fan runs only at "High" when triggered by the alerting unit but when turned on by the switch it runs at variable speed. Once triggered, the fan will run at "High Speed" until the Premier/Hotdog control box is switched off. Please note that the fan will remain on for 15 to 20 seconds after the control box is switched off.

The fan control box must be mounted to a metal surface to assist in dissipating heat from the resistor. Do not mount on a surface that is heat sensitive, as the control box will get hot during longer periods of operation.

The control for the fan can be mounted under the dash or to the dog cage to a metal surface with the screw clip provided. The control box generates heat. Be sure to study the position to mount the control keeping it away from heat sensitive materials such as plastic or vinyl.

Mounting Bracket Kit Mounting brackets slide into place

Consists of 4 brackets. 4 rods and 4 fixing bolt. 4 positions around the fan.

The Maxi Thin Fan can be surface mounted to the dog cage window grill covers.

• Remove the front metal grill cover from the Maxi Thin Fan.

• Remove the mounting bracket kit if attached to the fan.

• Find a location on the metal window grill on the glass side that will leave enough room for the window to
            freely move up and down without hitting the fan.

• Place one flat washer between the fan and the grill for each of the four mounting bracket holes.

• Place one flat washer on the top of the fan-mounting hole to protect the mounting bracket holes from damage.

• Use four nuts and bolts to secure the fan to the window grill.

• Also use a flat washer on the bolt to stop it from going through the grill.

• You may need to notch the top of the door cover in order to run the Maxi Thin Fan power wires to the control
            unit through the door cavity and boot, keeping wires out of K-9’s reach.

• Secure the wiring to the grill with tie wraps as needed to prevent them from being damaged.